Generally speaking, simply follow the steps outlined in the following article to install your Check'In 2:
However, in certain situations (e.g., in a basement or in the countryside), lack of network coverage may disrupt the installation of your Check'In 2. If this happens, we invite you to start the installation process in a location with better network coverage. Then, calibrate your Check'In 2 once you are at the installation location.
Steps to follow in a location with sufficient network coverage:
1 Complete all the instructions described in the "Getting started with the Check'In app" section of the article above.
2 Insert the batteries into your Check'In 2.
3 Skip the remaining steps in the "Setting up the device" section by tapping "Continue".
4 Wait for your Check'In 2 to connect to the network (this may take up to 10 minutes).
💡 If, after this time, your Check'In 2 does not emit a white light, reset it. To do this, press the button on the right side of the Check'In 2 for about 9 seconds. The LED will light up red, at which point you should release the button. You will hear a beep, indicating that the Check'In 2 has been reset and is rebooting. If you do not hear a beep, repeat the procedure.
5 Skip steps 2 and 3 in the "Activating the device" section by tapping "Continue".
🚨 As long as you are not in the location where you intend to install the Check'In 2, do not activate the sensors by pressing the Check'In 2 button twice! Skip this step as well as those asking you to open and close your door.
6 Continue with the installation tutorial until completion.
7 Once the tutorial is complete, and at your convenience, go to the location where you want to install your Check'In 2.
Steps to follow once on-site:
1 Install your Check'In 2 on its support (as indicated in the "Setting up the device" section of the Help Center article).
2 Tap the Check'In 2's button twice to activate the sensors. You will hear an activation melody.
3 Wait 10 seconds.
4 Open your door fully, then close it.
5 Press the Check'In 2's button three times to initiate a connection. Once connected, the opening and closing of your door will appear in your app’s history.
6 Your Check'In 2 is now ready to use! 🎉