Generally, simply follow the steps outlined in the following article to install your Check'In Pro 2:
However, in certain situations (e.g., in a basement or in the countryside), a lack of network might interfere with the installation of your Check'In Pro 2. If this applies to you, we invite you to start the installation process in an area with a better network. Then, calibrate your Check'In Pro 2, once you are at the installation location.
Steps to follow in an area with sufficient network:
1 Complete all instructions in the "Getting Started in the Check’In Application" section of the article above.
2 Insert the batteries into your Check'In Pro 2.
3 Skip the remaining steps in the "Device Installation" section by tapping "Continue".
4 Wait for your Check'In Pro 2 to connect to the network (this may take up to 10 minutes).
💡 If your Check'In Pro 2 does not emit a white light after this period, reset it. Press the button on the right side of the Check'In Pro 2 for about 9 seconds. The LED will turn red, at which point you should release the button. You will hear a beep, indicating that the Check'In Pro 2 has reset and is rebooting. If you do not hear a beep, repeat the process.
5 Skip steps 2 and 3 in the "Activating the Device" section by tapping "Continue".
🚨 Do not activate the sensors by double-tapping the Check'In Pro 2 button until you are on-site! Skip this step as well as the steps asking you to open and close your door.
6 Continue the installation tutorial to the end.
7 Once the tutorial is completed, and at your convenience, proceed to the location where you want to install your Check'In Pro 2.
Steps to follow once on-site:
1 Install your Check'In Pro 2 on its mount (as described in the "Device Installation" section of the Help Center article).
2 Double-tap the Check'In Pro 2 button to activate the sensors. You will hear an activation melody.
3 Wait 10 seconds.
4 Fully open your door, then close it.
5 Press the Check'In Pro 2 button three times to initiate a connection. Once the connection is established, the opening and closing of your door will appear in your application’s history.
6 Your Check'In Pro 2 is now ready to use! 🎉