If you want to move your Check'In Pro 2 to another location, for example after a move, here are the steps to follow:
Resetting the Check'In Pro 2
Press the button on the right side of the Check'In Pro 2 for about 9 seconds. Release it once the LED lights up red. You will hear a beep, indicating that your sensor has been reset.
💡 If you did not hear a beep, repeat the procedure!
💡 Wait until the LED stops blinking red before proceeding to the next steps. Otherwise, the Check'In Pro 2 reset will not have worked, and you will need to repeat the procedure.
Storing the Check'In Pro 2
Step 1: Remove the Check'In Pro 2 from its mount
To do this, remove the SafeStick located in the middle slot of the sensor (you can use the tip of a paperclip or a pen). Then place it in the top slot of the Check'In Pro 2. Slide the Check'In Pro 2 upwards to detach it from its mount.
Step 2: Remove the batteries from the Check'In Pro 2
💡 Make sure the LED has stopped blinking red and that you heard the beep. If you remove the batteries before, the Check'In Pro 2 reset will not work and you will need to repeat the procedure.
Step 3: Detach the Check'In Pro 2 mount from the door
Start by lifting the top of the mount. Then, pull gradually to release the adhesive. If you are concerned about damaging the mount, use a solvent or a heat source to remove the adhesive strips more easily.
💡 You can, for example, use a hairdryer to remove the adhesive strips.
Step 4: Remove the adhesive from the door
Depending on your door material, a small adhesive residue may remain. Remove it with your finger or a plastic tool (for example, a card). Scrape the adhesive vertically: it will roll up and detach gradually.
Step 5: Clean the door surface
If necessary, finish cleaning with a cloth soaked in solvent (for example, acetone).
Uninstalling the Check'In Pro 2
Open your Check'In app, then tap on the Check'In Pro 2 you want to uninstall. Go to the "Settings" tab, then "Advanced Information", at the bottom of the page. Tap on "Uninstall Check'In".
Reinstalling the Check'In Pro 2
Your Check'In Pro 2 can now be installed in a new location! 🎉
You can find the sensor installation process in the following article: